1. What will be the power if the PLAN for both 2-stroke and 4-stroke engine is same?
2. What is the indicator diagram?
3. What are the purpose of taking indicator diagram?
4. What are the types of indicator diagram?
5. What is indicated power? How to calculate power?
6. Steps to take indicator diagram?
7. Purpose of Power diagram, Out-of-phase diagram, Compression diagram, Light spring diagram?
8. When indicator diagram is taken?
9. What are the necessary precaution to avoid indicator malfunction?
10. What are the steps to be taken when compression pressure is low?

Workshop Practice, Brazing, Welding & Gas Cutting (Set 2)


Multiple Choice Questions


1. Which of the following definitions accurately describes "tool feed" when referring to lathe work?




2. The "pitch" of a screw is the ____________.




3. The diameter of a hole drilled for tapping threads into a piece of stock should be _____________.




4. A tapered shank drill is removed from the drill press spindle with a _____________.




5. Machine bolts are identified by their ______________.




6. Diamond point chisels are best used for cutting _______________.




7. When a lathe is used for thread cutting, the number of threads per inch produced is determined by the speed relationship between the ____________.




8. To remove a hand held right-handed straight cut reamer after it has gone all the way through a hole, you should _______________.




9. The proper file for a finishing cut on soft metal, such as brass, is the _____________.




10. To properly install a new blade in a hand hacksaw frame, the __________________.